Blasting for Max Coverage

This VW body pan had the full anti-corrosive treatment.

VW-PowderCoatedChassis

Schedule of work:
Clean and remove dirt & grease contaminants, blast clean leaving a clean etched & rust free surface.

Apply 100 micron coat of 99.9% pure zinc metallization coating all areas and masking off all threads. Degas to remove any trapped gas built up within the zinc coat.

Remove from the curing oven and apply the first coat of Gloss black Plascoat PPA-571 (no primer coat required) whilst the material is still hot, this helps adhesion to the more difficult parts to reach .Bake off and reapply second hot coat. The overall final coats will be around 300 microns inc zinc coat. The added weight to this will be around 8 kgs.

http://ctc-powder-coating.co.uk/plascoat/ .

This system not only gives a high gloss or semigloss finish it also offers extreme long term anti corrosion properties. There are other colours in the range to choose from. Yellow, Blue, Light or dark grey, brown, black, red, green & white.

The overall cost on this project came to £450.00 plus vat. Making the work cost effective and reliable in the long term over the traditional work.

Further information.
The metallization system can be used on most car body parts, motorcycle frames and products used in extreme conditions. . Aluminium panels are not suitable for zinc metallization due to the re-action between the two materials, however a pure aluminium material is used that also offers very good long term protection. Also on offer is. Copper, brass, babbitt and many more materials including pure silver & gold.

Another point to note is for zinc or Aluminium spray can also be used to fill small corrosion damage and pin holes, thus saving time and effort using standard unreliable body fillers. Please note this will not give any structural strength.

For inner surfaces that can not be treated or reached as box rails we can apply a heavy coat of Wax oil to finish the job if required.

So if you are serious and want the best possible long term solution that any car restoration company would be very hard pushed to match then the above system is the one to choose.

MSB would be happy to work alongside any restoration company to advise and offer this service.

Please feel free to contact our office on 01621 841100.

Plascoat offers.
Superior resistance to sun, salt and sea water
Excellent impact and sand abrasion resistance
Premium quality, glossy appearance
Will not crack, chip, flake or fracture
Low temperature performance to -70°C
Excellent adhesion to steel, iron and aluminium
No requirement for a primer